ATTO Technology 2390 Setup Guide download pdf (Page 34)

WHT

BLK

RED

GND

OEM-2K: MALE DB9

OEM-LH: FEMALE DB9

MALE DB9

2 - RX -

7 - RX +

3 - TX -

8 - TX +

2 - TX -

7 - TX +

3 - RX -

8 - RX +

4 - GND (SHIELD) 4 - GND (SHIELD)

PAIR 1

PAIR 2

Standard VTR Control Cable:

Linux(AJA) Controlling VTR (Normal Video I/O Control Cable)

Linux(AJA)

VTR

RS-422

Setting Up VTR Emulation

You can configure your Autodesk Visual Effects, Finishing, and Colour Grading application to emulate a

VTR for both input and output in real time. You control the emulator from the application or device that

sees the Autodesk Visual Effects, Finishing, and Colour Grading application as a VTR.

The following procedure describes how to configure the hardware for VTR emulation. Consult the “VTR

Emulation” chapter in your application User Guide for more information.

To configure hardware for VTR emulation:

1 Connect the video I/O cables between the devices involved in the VTR emulation process

(out-to-in/in-to-out). Make sure the connections support the video standard you want to work with.

If you intend to use the emulator as a Player, it is recommended that you connect one black or colour

bar SDI signal to the input of the system serving as the VTR emulator. This ensures the Player is stable

and correctly synced.

NOTE This applies to an Autodesk Visual Effects and Finishing application only: VTR emulation requires a

workstation with a video board. The Video keyword for the corresponding device must be uncommented in

the software initialization configuration file, init.cfg. See the description of the Video keyword in the Autodesk

Visual Effects and Finishing Configuration File Reference Guide.

2 Connect the audio I/O cables between the devices involved in the VTR emulation process

(out-to-in/in-to-out).

28 | Chapter 4 Setting Up Video Hardware

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 43 44

No comments

ATTO Technology 2390 Setup Guide Page 34