ATTO Technology 2390D Setup Guide download pdf (Page 124)

4 Enter a different port at the end of the SERVER line.

The license server can use a default port number in the range of

27000-27009.

For example, to use port 62222, add 62222 to the end of the line:

SERVER server DLHOST01=886C2B75E8E57E4B03D784C3A2100AC0

62222

5 Save and close the file.

6 Verify that the new port settings are correct. Type the following

commands:

/etc/init.d/license_server stop

/etc/init.d/license_server start

cat /usr/discreet/licserv/log/license_server.log

NOTE For redundant license servers, reboot each server in close sequence

to properly restart the license system.

7 Look for messages similar to the following examples in the output, and

verify that the port numbers are what you requested:

15:08:49 (lmgrd) lmgrd tcp-port 6222215:08:49 (lmgrd)

Starting vendor daemons ...15:08:49 (lmgrd) Using vendor

daemon port 12344 specified in license file15:08:49

(lmgrd) Started discreet_l (internet tcp_port 12344 pid

5013)

8 Log in as root to each workstation on the network, open the file

/usr/local/flexlm/licenses/DL_license.dat in a text editor, and repeat steps

3 and 4 in this procedure, using the same port as the one you set for the

license server.

Starting the License Server

NOTE For redundant license servers, reboot each server in close sequence to

properly restart the license system.

To start the license server:

1 Type the following in a shell:

/etc/init.d/license_server start

114 | Chapter 5 Licensing and Starting

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 251 252

No comments

ATTO Technology 2390D Setup Guide Page 124