ATTO Technology 2390D Setup Guide download pdf (Page 56)

To verify and upgrade the AJA firmware:

1 Open a terminal, log in as root.

2 Go to the /usr/discreet/DKU/current/Utils/AJA_firmwareUpdate directory.

3 Run the AJAfw_update utility to scan the AJA current firmware and, if

required, update to the latest firmware version. Type:

./AJAfw_update

4 If you have an AJA OEM-2K card, you must start the firmware update

by typing Y and then pressing Enter.

If you have a AJA Kona 3G, the upgrade begins automatically.

While the AJA firmware and drivers are being updated, your workstation

appears to be frozen and your mouse and keyboard do not work. This is

normal and indicates that the firmware is being updated. Once the

firmware update is complete, you are returned to the terminal.

5 Shut down your workstation by typing:

shutdown -g0

If your workstation does not prompt you to power down, press the power

button for 10 seconds to force a power down.

6 Disconnect the power cord.

7 Wait 10 seconds, reconnect the power cord, then restart your workstation.

Configuring Storage

Overview

This chapter describes how to configure a direct-attached storage array

connected to the workstation.

If you are also configuring a Storage Area Network (SAN), it is recommended

that you configure the SAN prior to configuring a direct-attached storage.

Before you can configure the storage, the workstation must be up and running

the custom Autodesk distribution of Red Hat Enterprise Linux, as well as the

version of the DKU required for your application version.

WARNING When configuring a storage array, it is strongly recommended to

disconnect any other storage device (DAS or SAN) connected to the workstationso

that you do not reconfigure the wrong device.

46 | Chapter 2 Preparing your Workstation

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 251 252

No comments

ATTO Technology 2390D Setup Guide Page 56