ATTO Technology 2390D Setup Guide download pdf (Page 46)

WARNING You must use this exact command to start the Linux installation.

If you use the default options presented by the Linux installation prompt,

the installation proceeds, but some important packages required by Autodesk

software are not installed.

The command launches the Linux installation. The system spends several

minutes loading drivers. The installer guides you through the rest of the

process.

11 The installation process may ask you to initialize the system disk. Follow

the prompts to initialize the disk, if necessary.

12 The remainder of the installation process is automated.

When the installation completes, you are prompted with

“Congratulations, the installation is complete”.

13 Eject the disc and click Reboot to reboot the system. After the system

reboots, perform the post-installation tasks in the following section.

NOTE After the system reboots, you may be prompted by the Kudzu

hardware setup utility to set up new hardware detected for your system. You

can ignore these prompts and allow the utility's count-down to expire since

the hardware for the system is unchanged.

Linux Post-Installation Tasks

After booting into your new Linux installation, perform the following

post-installation tasks:

1 Change the default root password to secure the system.

■ Log into your system as root, using the default password password.

■ Open a terminal and type:

passwd

■ Enter your current password when prompted, and then enter the

new password.

2 Configure the time zone for your geographic location. The automated

Autodesk installation sets the time zone to North American Eastern

Standard Time (EST) by default.

■ Log into the Linux Desktop as root.

■ Right-click the clock, and select Configure Clock from the context

menu.

36 | Chapter 2 Preparing your Workstation

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 251 252

No comments

ATTO Technology 2390D Setup Guide Page 46