ATTO Technology 2390D Setup Guide download pdf (Page 55)

WARNING If you attempt to install the DKU on an unsupported platform,

the installation script only installs a generic configuration. Such a

configuration can render your operating system unusable. Never attempt

to install the current version of the DKU on unsupported platforms, including

older Creative Finishing systems that are no longer supported in the current

version.

When the DKU installation script completes, a warning to update the

AJA card or DVI-Ramp firmware may appear and you are returned to the

command prompt. See the following section for information on updating

your AJA card firmware.

5 If you installed from a disc, return to the root directory, and eject the

disc by typing:

eject

6 Before rebooting the system, make sure that the Wacom tablet is

connected. If storage devices (external disk arrays or internal storage)

were previously disconnected or turned off as part of an operating system

installation, reconnect them and power them up.

NOTE Power on the XE expansion enclosures first and the XR RAID controller

units last. This ensures the RAID controllers detect the other units in the

Stone Direct storage.

Wait for all the disks in the storage devices to fully power up before

rebooting the system. The green light for each disk stops flashing once

it is fully powered up.

7 Reboot the system. Type:

reboot

NOTE After the workstation reboots and until you install the application,

the Wacom tablet might not behave correctly. Installing the application,

then logging out of the KDE desktop and logging back in should eliminate

this problem.

Upgrading the AJA Firmware

The AJA firmware update utility is distributed with the DKU. It checks the

firmware version and upgrades the firmware if necessary.

NOTE Before upgrading the AJA firmware, make sure you have upgraded the DKU,

and that you have restarted the system.

Installing the DKU and the AJA OEM-2K Firmware | 45

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 251 252

No comments

ATTO Technology 2390D Setup Guide Page 55